|
FEATURES
- 14-slot form factor backplane
- One PICMG® 1.0 Single Board Computer slot
- Ten (10) 32-bit PCI slots
- Two (2) ISA slots
|
STANDARDS
PICMG 1.0 |
FORM FACTOR
14-slot, one segment |
DIMENSION ENVELOPE
12.3” x 10.1”
See mechanical layout for detailed dimension information. |
|
NUMBER OF PROCESSOR SLOTS
1- Accepts industry standard PICMG 1.0 compatible single board computers. |
OPTION CARD SLOTS
12 |
EXPANSION SLOT
Not Applicable |
Suggested SHB/SBCs
MX8
T4G
T4R
T4I |
|
ETHERNET INTERFACES
Not applicable |
I/O INTERFACES
Not applicable |
POWER INDICATORS
LEDs provide a convenient visual check for +5V, -5V, +12V and +3.3V power connection and status.
CAUTION: When the power indicators are on do not install or remove the SBC or any option card from the BP3/10 backplane.
|
POWER CONNECTORS
The BP3/10 backplane is available with a vertical AT or ATX power connector. The power connection for +3.3V is available through a 12-pin .156 MTA connector or the optional ATX connector. |
|
OPTION CARD SLOT DETAILS
PCI/ISA Slots
SLTA1, SLTA2,
SLTB1, SLTB2, SLTB3, SLTB4
SLTC1, SLTC2, SLTC3, SLTC4 – PCI, 32-bit/33MHz
SLT11, SLT12 – ISA
See mechanical layout for detailed slot routing information. |
|
MISCELLANEOUS BACKPLANE INFORMATION
PCI-TO-PCI BRIDGE
The PCI-to-PCI bridge supports the PCI 2.1 specification. This bridge allows PCI Local Buses to extend the electrical loading limits of a single PCI Bus and to operate independently, allowing for communication within the same bus even if the other PCI Buses are busy. The BP3/10 backplane has bus mastering capabilities on all 10 PCI Local Bus Slots.
PCI LOCAL BUS SLOTS
Provides 10 PCI Local Bus slots. |
